铸造杂志社

No.4	2022
•	封面图-Vol.19 No.4 2022
•	Contents-Vol.19 No.4 2022
•	Effect of nitrogen on micro-pores in DD33 single crystal superalloy during solidification and homogenization
•	Simulation and experimental research on extra-squeeze forming method during gradient sand molding
•	Application of transparent casting moulds prepared by additive manufacturing technology in hydraulic simulation
•	Sub-pixel high precision dimensional measurement method for aero-engine hollow turbine blade based on industrial computed tomography image
•	Effects of Cu content on microstructure and mechanical properties of rheo-diecasting Al-6Zn-2Mg-xCu alloys
•	Design and application of a multichannel "cross" hot tearing tendency device: A study on hot tearing tendency of Al alloys
•	Effect of high magnetic field on solidification microstructure evolution of a Cu-Fe immiscible alloy
•	Iterative reverse deformation optimization design of castings based on numerical simulation of solidification thermal stress
•	Optimization of investment casting process for K477 superalloy aero-engine turbine nozzle by simulation and experiment
•	Revealing effect of aluminum alloying on work hardening and impact behaviors of low-density Fe-18Mn-1.3C-2Cr-(4, 11)Al casting steel